EN

Phasor problems

Phasor operations and AC exercises solved step by step

1. Phasor calculator

Operation
°
°

2. Practice problems

Problem type

What a phasor is

In alternating current, every voltage and current of a linear circuit is a sinusoid of the same frequency; only the amplitude and phase change. A phasor is a complex number that keeps exactly those two things: its magnitude is the amplitude (or rms value) and its angle is the phase. With phasors, derivatives and integrals of sinusoids become products by jω, and the circuit is solved with the same rules as in DC, using complex impedances instead of resistances.

\[ v(t) = V_m \sin(\omega t + \varphi) \;\Leftrightarrow\; \underline{V} = V_m \angle \varphi \]
\[ Z_R = R \qquad Z_L = j\omega L \qquad Z_C = \frac{1}{j\omega C} = -\frac{j}{\omega C} \]

Rectangular and polar form

A phasor is written in rectangular form (a + jb, real and imaginary parts) or in polar form (magnitude ∠ angle). To add and subtract, use the rectangular form, adding real and imaginary parts separately; to multiply and divide, use the polar form, multiplying or dividing magnitudes and adding or subtracting angles.

\[ a = M\cos\varphi \qquad b = M\sin\varphi \]
\[ M = \sqrt{a^2 + b^2} \qquad \varphi = \operatorname{atan2}(b,\ a) \]
\[ (M_1\angle\varphi_1)(M_2\angle\varphi_2) = M_1 M_2 \angle(\varphi_1 + \varphi_2) \]

Watch the angle when converting from rectangular to polar: with a negative real part, the plain arctangent gives an angle that is 180° off. The atan2 function, or checking which quadrant the phasor falls in, avoids this.

How to solve a circuit with phasors

  1. Turn the sources into phasors, all with the same convention: rms or peak values, and the same reference function (sine or cosine).
  2. Work out the impedance of each element at the operating frequency.
  3. Solve as in DC: series and parallel combinations, dividers, Kirchhoff, nodal or mesh analysis, with complex numbers.
  4. Check: in a series circuit, the sum of the element voltage phasors must equal the source voltage.
  5. If asked, go back to the time domain: the magnitude gives the amplitude and the angle the phase.

In the circuit problems on this page the source is 230 V rms at 50 Hz with 0° phase, so the results are rms values. The sinusoid sums use peak values.

See also: RLC circuit, Source conversion, Power factor correction and Power measurement with wattmeters.