A practical source can be represented in two ways: as an ideal voltage source with a series resistance (Thévenin model) or as an ideal current
source with the same resistance in parallel (Norton model). The two are equivalent as seen from their terminals: connect the same load to either
and it receives exactly the same voltage and current. All that is needed is the same resistance and a current-source value equal to the short-circuit
current, Vs/R.
To check it, look at the two extremes. Open-circuited, the voltage source gives Vs, and the current source drives all of Is through the
parallel resistance: Is·R = Vs. Short-circuited, the voltage source delivers Vs/R and the current source delivers all of
Is into the short. Since the circuit is linear and agrees at two points, it agrees everywhere.
What it is for
Simplifying circuits: voltage sources in series add up, and so do current sources in parallel. Converting one into the other lets you merge
branches until a single source and resistance remain. That is how section 2 is solved: each source is turned into a current source, the currents are
added, the resistances combined in parallel, and the result turned back into a voltage source.
Preparing an analysis: nodal analysis works best with current sources and mesh analysis with voltage sources. Converting first saves equations
(see circuit analysis).
Thévenin and Norton: the two equivalents of a circuit are related by this same conversion
(see Thévenin and Norton).
Common mistakes
Only valid outside: the power lost inside each model is different. Open-circuited, the voltage model dissipates nothing, while the current model
dissipates Is²·R. The calculator shows it: the load power matches, the internal resistance power does not.
Ideal sources: a voltage source with no series resistance (R = 0) has no current equivalent, and a current source with no parallel resistance
(infinite R) has no voltage equivalent.
Direction: the arrow of the current source points towards the positive terminal of the equivalent voltage source.
Alternating current: the conversion is the same with impedances and phasors: Is = Vs/Z, with the same Z in parallel
(see phasor problems).