EN

IEC–NEMA / NEMA–IEC Converter

Convert IEC wire combinations to NEMA and vice versa

Operation

Did you receive a motor with a different measurement system? Use this converter

Input type


What it is for

It moves a winding from one standard to the other: from AWG gauges (NEMA) to diameters in millimetres (IEC), or the other way round. You need it when an American motor arrives and you only have metric wire, or when you follow a diagram with data in the other standard. There is no exact equivalence between the two series, so it proposes combinations that match the copper section.

How to use it

  1. Choose what you have as input, AWG or Metric, and press Continue.
  2. Select the original gauges or diameters, with one row per wire if several are in parallel. Press Continue again.
  3. If there are wires in the target standard that you do not have, add them to the exclusion list.
  4. Set the tolerances and the wire range, and press Calculate.

The exclusion list belongs to the output standard: if you enter AWG, you exclude diameters; if you enter metric, you exclude gauges.

How to read the result

The target section appears above the table. Each row gives the wires that go together, in mm if the output is metric or as an AWG number if it is NEMA, the section they add up to and the difference. If nothing appears, widen the tolerance.

Examples

Table of approximate equivalents

The metric diameter in the last column is just the closest and does not have the same section. For a reliable result, calculate with the tool.

AWGDiameter (mm)Section (mm²)Nearest metric (mm)
141.6282.0811.60
161.2911.3091.30
181.0240.8231.00
200.8120.5180.80
220.6440.3260.65
240.5110.2050.50
260.4050.1290.40
280.3210.0810.30
300.2550.0510.25

Before you decide