EN

Asynchronous Motor Turns Calculation

Find out the required turns based on slot dimensions

Operation

By knowing the slot dimensions you can calculate the possible turns

Choose the slot type

Select the diameters

What it is for

It calculates how many enamelled wires fit in a stator slot according to its shape, its dimensions, the insulation and the wire diameter. It tells you whether a winding is possible before you cut any wire: if the turns you calculated do not fit, you need to change the wire, split it in parallel or review the calculation.

How to use it

  1. Choose the slot shape closest to yours.
  2. Select the wire diameter, without enamel. If you will wind with several wires in hand, add one row for each.
  3. Enter the thickness of the insulating paper and the slot dimensions in millimetres.
  4. Press Calculate.

What to measure on each slot

ShapeDimensionsWhat it looks like
Trapezoidalh, W, wW is the width at the bottom and w the width next to the opening.
Straighth, WConstant width W. Leave w empty.
Roundedh, WConstant width W with both ends rounded. Leave w empty.
Asymmetric roundedh, W, wRounded at both ends, with one end wider (W) than the other (w).

h is always the total height of the slot. If the lamination is worn or hard to measure, take a template of the slot with card and measure that.

How it calculates

It first gets the slot area and subtracts the paper: perimeter times thickness. It then applies a 75% fill factor and divides by the real area of each wire, adding the enamel with an approximate thickness of 0.012 + 0.022·√d mm per side.

\[ N_{\max} = \frac{0.75\,(A_{\text{slot}} - P \cdot t_{\text{paper}})}{\sum A_{\text{wire}}} \]

How to read the result

Example

A rounded slot with h = 20 mm and W = 8 mm, 0.3 mm paper and 0.80 mm wire: 168 wires fit. If the motor needs 30 turns per slot, you could use up to 168 / 30 = 5 wires in hand, rounding down. That is 2.51 mm² of copper per turn.

Limits

To split a section into thinner wires, use IEC equivalences or NEMA equivalences. For the number of turns, use Turns by stator.