EN

IEC Conductor Equivalences (metric)

Convert cross-sections or diameters into other combinations

Operation

Don’t have the original diameters? Use this converter to obtain correct equivalences

Input type

Select diameters


What it is for

It finds combinations of metric enamelled wires, in parallel, with the same section as the wire you need. This is common when the workshop does not stock that diameter or when a thick wire is hard to fit in the slot. What matters is the copper section, not the diameter: two 0.70 mm wires are not equivalent to one of 1.40 mm, but to one of almost 1 mm.

\[ S = \frac{\pi\,d^2}{4} \]

How to use it

  1. Choose the input type: Diameters of the original wire (one or several) or Section in mm².
  2. Press Accept to see the options.
  3. Under Diameters to exclude, add the ones you do not have. If you exclude the original diameter, the result only shows alternatives.
  4. Set the tolerances: how much more or less section you accept.
  5. Choose the wire range and press Calculate.

How to read the result

The table runs from largest to smallest section. Each row gives the diameters that go together, the section they add up to and the difference from the target. A positive percentage means more copper; a negative one, less.

If nothing appears, widen the tolerance or the number of wires. With the initial tolerance (1% above and 0% below) it is normal to get few combinations. The search covers wires up to 1.95 mm and only combines similar diameters, with a maximum difference of 0.10 to 0.25 mm depending on the section: in parallel, very different wires are awkward to wind together.

Example

An original 1.00 mm wire (0.785 mm²) that you do not have in the workshop. Exclude 1.00 with 5% tolerances and up to 3 wires. Among others, you get:

Wires (mm)Section (mm²)Difference
0.65 + 0.750.774−1.5%
0.70 + 0.700.770−2%
0.55 + 0.60 + 0.600.803+2.25%

The 0.70 + 0.70 pair is the most convenient because it uses a single diameter.

Section table

Diameter (mm)Section (mm²)
0.300.071
0.400.126
0.500.196
0.600.283
0.700.385
0.800.503
0.900.636
1.000.785
1.201.131
1.401.539
1.602.011
1.802.545

Before you decide