EN

Ohm's law and electrical power

Calculate V, I, R and P, resistors in series and parallel, and AC power

Ohm's law calculator

Enter any two values (voltage, current, resistance or power) and leave the other two empty. The calculator finds the missing ones and shows the formula used.

Data (fill in two)
Energy and cost (optional)
h
/kWh

Resistors in series and parallel

Enter the values separated by spaces or commas. Suffixes are accepted: 470, 4.7k, 4k7, 2M2, R47 (0.47 Ω). If you enter the supply voltage, you will also see the voltage, current and power of each resistor.

Resistors

AC power

In AC, the useful power depends on the power factor (cos φ). In three-phase systems the line-to-line voltage is used.

Load data

What Ohm's law says

The current flowing through a conductor is proportional to the applied voltage and inversely proportional to its resistance. Georg Simon Ohm formulated it in 1827, and it is the basis of all circuit calculations.

\[ V = I \cdot R \qquad I = \frac{V}{R} \qquad R = \frac{V}{I} \]
QuantitySymbolUnitCommon multiples
Voltage (potential difference)V or Uvolt (V)mV, kV
CurrentIampere (A)µA, mA, kA
ResistanceRohm (Ω)mΩ, kΩ, MΩ
PowerPwatt (W)mW, kW, MW
EnergyEjoule (J) or kWh1 kWh = 3.6 MJ

A handy way to remember it is the VIR triangle: V on top, I and R below. Cover the quantity you want and the rest shows the operation: V = I · R (they are side by side), I = V / R and R = V / I.

Electrical power formula

Power is the energy converted per unit of time. In DC (and in AC with resistive loads) it is \(P = V \cdot I\). Substituting Ohm's law gives the other two forms, which are very useful to find out how hot a resistor will get:

\[ P = V \cdot I = I^2 \cdot R = \frac{V^2}{R} \]

Combining both laws gives the 12 formulas of the Ohm's law wheel: with two known quantities you can calculate the other two.

PV IR V·II²·RV²/R I·RP/I√(P·R) V/RP/V√(P/R) V/IV²/PP/I²
Ohm's law wheel: the unknown quantity is in the centre and the outer sector shows the three ways to calculate it.

Resistors in series, in parallel and dividers

AC power: active, reactive and apparent

With motors, transformers or fluorescent lamps the current lags the voltage by an angle φ, and three powers appear: active power P (W), which does the useful work; reactive power Q (var), which builds the magnetic fields; and apparent power S (VA), which is used to size cables and transformers.

\[ \text{Single-phase: } P = V\,I\cos\varphi \qquad \text{Three-phase: } P = \sqrt{3}\,V_L\,I_L\cos\varphi \qquad S = \sqrt{P^2 + Q^2} \]

Solved examples

1. Current through a 100 Ω resistor at 12 V

\(I = \frac{V}{R} = \frac{12}{100} = 0.12\ \text{A} = 120\ \text{mA}\). Power dissipated: \(P = V \cdot I = 12 \cdot 0.12 = 1.44\ \text{W}\). A 1/4 W resistor would burn out: a 2 W one is needed.

2. Resistance and current of a 2000 W heater at 230 V

\(I = \frac{P}{V} = \frac{2000}{230} = 8.7\ \text{A}\) and \(R = \frac{V^2}{P} = \frac{230^2}{2000} = 26.45\ \Omega\). Running for 3 hours it uses \(2 \cdot 3 = 6\ \text{kWh}\).

3. Resistor for an LED

A red LED (2 V, 20 mA) at 12 V needs a series resistor that drops \(12 - 2 = 10\ \text{V}\): \(R = \frac{10}{0.02} = 500\ \Omega\) (choose the standard 470 Ω or 560 Ω) and \(P = 10 \cdot 0.02 = 0.2\ \text{W}\).

4. Three-phase motor at 400 V, 10 A and cos φ = 0.85

\(P = \sqrt{3} \cdot 400 \cdot 10 \cdot 0.85 = 5.89\ \text{kW}\), \(S = \sqrt{3} \cdot 400 \cdot 10 = 6.93\ \text{kVA}\) and \(Q = S \sin\varphi = 3.65\ \text{kvar}\).

Common mistakes

Related: Kirchhoff's laws, Thévenin and Norton, RLC circuit and cable voltage drop.