Draw the circuit and get voltages, currents and powers, with nodal or mesh analysis
Draw the circuit, press Solve and you will get the voltage, current and power of every element, the voltage of every node and the step-by-step solution by nodal or mesh analysis. For AC, three-phase or sources with several frequencies there is the AC circuit analyser.
How to draw. Press an element to add it and drag it. Press one terminal and then another to join them with a wire: on the way, a click on empty space makes a corner and a click on a wire opens a junction. With an element selected, change its data in the panel. The R key rotates and Delete removes; there are also buttons. A selected switch opens or closes with another click.
Examples:
You have changed the circuit: press Solve to update the results.
Results
Elements
V is the voltage of the first terminal minus that of the second; I flows from the first terminal to the second through the element. Negative P: it delivers power.
Node voltages
With respect to ground.
Step-by-step solution
Nodal or mesh
The numerical results are the same with both methods; what changes is the step-by-step working shown.
Nodal (modified nodal analysis): the unknowns are the node voltages with respect to ground and the current of each voltage source. It works for any circuit.
Mesh (modified mesh analysis): the unknowns are the mesh currents, clockwise like the purple arrows on the diagram, and the voltage of each element that sets its own current (current sources, current-dependent sources and capacitors, which pass no current in DC). The meshes are taken from the drawing, so the circuit must be drawn without wires crossing without a junction and with the grounds joined by wires.
Elements
Battery: voltage source with its internal resistance in series. The + is the terminal of the long plate.
Potentiometer: total resistance and wiper position, from 0 % (next to the first terminal) to 100 %. It is calculated as two resistors, between each end and the wiper.
Lamp: given by its rated power and voltage, as printed on the bulb. It is calculated as a resistance U²/P and the percentage of its rated power it works at is shown. A real lamp has a lower resistance when cold.
Switch: closed is a short circuit and open, an open circuit.
Ammeter and voltmeter: ideal, with their reading on the diagram. The ammeter has no resistance and can also be the control variable of a dependent source (the current through it). The voltmeter draws no current.
Inductor and capacitor: in DC steady state, the inductor is a short circuit and the capacitor an open circuit. To see how they charge there is DC transients.
Dependent sources: V controlled by V, V by I, I by V and I by I, controlled by the voltage or current of another element.
Conventions
The voltage source has its + on the first terminal, on the left when not rotated. The current source pushes current in the direction of its arrow.
The voltage of each element is that of its first terminal minus that of the second, and the current flows from the first to the second through the element.
Negative P means that element delivers power. A load absorbs; a source usually delivers.
If the diagram has no ground, voltages are given with respect to one of its nodes.
Limits. It is linear steady state: it does not calculate transients or non-linear elements such as diodes or transistors, and a lamp is taken with its hot resistance. Always check that the results make sense.