EN

Single-phase windings

Tool for drawing single-phase windings

Single-phase motor winding: input data

Fill in the motor data. Fields that do not apply to your case are hidden automatically. It is for induction motors with main and auxiliary (starting) windings; universal motors and shaded-pole motors are not covered.

In development. This tool can already be used, but it is still in progress and works within limits: it draws main and auxiliary windings 90 electrical degrees apart, concentric or lap, if the slot count is a multiple of the poles. Nameplate data, capacitors and stator dimensions are not used in the calculation: it does not yet work out turns or wire size. Always review the diagram before winding; you can check it in Single-phase field checker.
How do you want to do it?
The winding you choose in section 6 is drawn, if it can be made with your data. All possible windings are proposed for whatever you leave unselected, from best to worst field; choose one and it is drawn.
1. Nameplate data
Optional
Optional
A
Optional
Optional
2. Voltage
Dual voltage
The main winding is in two halves: in parallel for the lower voltage and in series for the higher
V
Optional
V
Optional
3. Starting type
Optional
µF
Optional
µF
Optional
Reversing
Brings out the auxiliary winding ends as well
4. Poles
I know…
rpm
The poles will be worked out from the speed and frequency
5. Stator
mm
Optional
mm
Optional
mm²
Optional
6. Winding layout
Half and half is usual with a run capacitor; otherwise 2/3 and 1/3
Optional
Coil pitch
Optional: slots taken off the full pitch (0 = full pitch, 1 = one less). If left empty, the closest to 5/6 of the pole pitch.